Permanent Products

Enclosure:- The U3000/U4000 enclosure is IP65 rated.
‘A’ Transducers:- 13mm OD to 115mm OD pipes.
‘B’ Transducers:- 50mm OD to 2000mm OD pipes.
Optional Transducers:- For pipes 1500mm up to 5000mm contact Micronics.
Transducer Operating Temp:- ‘A’&‘B’ -20°C to +135°C.
Outputs:– Opto Isolated 0/4 –20mA; RS 232/USB (U4000 ONLY); Pulse Output – Programmable Pulse Width from 2ms - 500ms; Two programmable Alarms-High/Low flow, Volume or error.
Data Logger (U4000 ONLY):– Built in data logger with 198,000 data points which can be configured to log flow rate and/or total flow. Real time or stored data can be displayed locally in text or graph format, and downloaded via RS232 or USB port to Windows based PC.
Accuracy:- +/- 0.5% to +/- 3% depending on pipe size for flow rate > 0.2m/s.

Click hereto request a quote.

Enclosure:- Watertight and dustproof (IP66).
Power Input:- 100-240VAC, 50/60HZ., 5.28 watts, 9-36VDC.
Outputs:- 3x Isolated 4-20mA into 1000 ohm load. Programmable for Flow, Level or Velocity. RS 232 Option Serial and Windows Software.
Relays:- 2 x form ‘C’ dry contacts rated 5 amp SPDT Programmable for Flow Proportional pulse (sampler/totalizer) flow and/or level alarm.
Velocity Range:- 0.11 to 6.2m/sec.
Level Range:- Minimum Head 25.4mm to maximum head 4.5m. Accuracy:-
Level:- 0.25% of Range,
Velocity:- +/-2% of Reading,
Linearity and Repeatability:- +/- 0.1%.

Click hereto request a quote.

Pipe Range:- >13mm up to 4.5m.
Power Input:- 100–240VAC, 50/60Hz, 3watts max.
Flow Rate Range:- -12.2m/s to 12m/s in most applications.
Accuracy:- +/-2% of full scale. Requires solids
or bubbles of minimum size 100 microns,
minimum concentration 75ppm.
Repeatability:- +/- 0.1%.
Linearity:- +/-0.5% of full scale.
Display:- White, backlit matrix – displays flow rate, totalizer, relay states, operating mode and calibration menu.
Output:- Isolated/4–20mA (1000ohm load max.) 5amp rated SPDT relays, programmable flow alarms and/or proportional pulse. Adjustable sensitivity and damping.
Electronics Operating Temp:- -23°C to +60°C.
Sensor Operating Temp:- -40° to +93°C (-40° to 200°F)
Options:- 9-32VDC.  Intrinsic Safety Barriers, for sensor mounting in hazardous locations, SE3H High Temperature model rated up to 150°C, ISE Insertion type for special applications.  Enclosure Heater for outdoor installation, 16watt thermostatically control to -40°C.  Data Logger Built-in 2 million point logger with USB output and Windows software.

Click hereto request a quote.

Electronics:- Wall mounting 175x125x75mm.
Power Input:- 100 – 130VAC, 50/60Hz, 4.2watts.
200 – 260VAC, 50/60Hz, 4.8watts. Optional
24VDC, 3.6watts. Surge protection on power Input.
Output:- 5amp relay, DPDT.
Set Point:- On/Off adjustment – 0.1 to 3m
per sec.
Time Delay:- Switch selectable.
Failsafe Mode:- Switch selectable.
Indication:- Relay status and signal strength LED’s.
Pipe Range:- 12.5mm ID to 4.5m ID.
Sensor cable:- Surge protected, 5m-Shielded Coax
Optional:- 15m.
Hazardous Locations:- Intrinsic safety
Barriers option.

Click hereto request a quote.

Enclosure:- Polycarbonate (IP66). Shatterproof clear Front Panel.
Power:- 100-130VAC/200-250VAC, 50/60HZ & 6.2watts max.
Option:- 9-36VDC.
Outputs:- Isolated 4-20mA, 1000 ohm load maximum. Can be user-configured to 0-5V output. USB and isolated RS232 for data log transfer by cable connection to a PC, or dial-up connection through modems.  Programmable baud rates of 9600 or 19,200. 3 Relays, form “C” dry contacts rated 5 amp SPDT, programmable level alarm, flow proportional pulse (sampler/totalizer) echo loss and air temperature alarm.
Sensor Specification:- Maximum range: 4.57m.
Dead Band:- Programmable. Minimum 200mm.
Beam Angle:- 8°.

Click hereto request a quote.